Ford 351W V8 Pro Billet Distributor

Upgrade your Ford 351 Windsor (351W) V8 with this Pro Billet distributor, built with a magnetic pickup trigger for use with a compatible external ignition box and coil. This setup is designed for higher-output ignition systems on Mustang, Bronco, F-Series, Torino, Ranchero, Cougar, and Montego applications.

This distributor is built specifically for the 351W and will not fit 351 Cleveland (351C), 351 Modified (351M), or any other Windsor displacement (221, 260, 289, 302). The housing is machined aluminum with a steel drive gear best matched to cast iron hydraulic or solid flat-tappet camshafts, and rotation is counterclockwise. Requires a compatible external ignition box and a coil rated at 35,000 volts or higher; also requires a 12-volt electrical system with an alternator and is not compatible with generator-based charging systems or vehicles still running an active ballast resistor in the ignition circuit — the resistor should be removed or bypassed as part of installation. Timing is set through mechanical advance only.

What Is a Pro Billet Distributor?
A Pro Billet distributor uses a magnetic pickup trigger but, unlike HEI or Ready-to-Run designs, requires a separate external ignition box in addition to an external coil rather than housing that control on board. This setup is common in higher-output or race-oriented ignition systems where the buyer wants to pair the distributor with a specific external box and coil combination rather than an all-in-one unit.

Performance Benefits
The magnetic pickup trigger delivers consistent, wear-free timing signal without the point drift of older breaker-point systems. Because the ignition box and coil are external and separately selected, this setup allows the ignition system to be matched to higher-output requirements than a self-contained distributor typically supports. Mechanical advance handles the timing curve on the 351W specifically, keeping the system straightforward to set up and tune.

COMPATIBLE WITH
FORD SMALL BLOCK WINDSOR V8
• 5.8 L / 351 in³ (351W)

NOTES
• Designed for Ford 351 Windsor carbureted applications.
Will not fit 351C (Cleveland) or 351M (Modified) engines — those are a different engine family.
• Will not fit any other Windsor displacements (221, 260, 289, 302).
• The 351W was produced with a carburetor through 1988; after 1988 all 351W engines were equipped with EFI and are not compatible with this distributor.
• This distributor is designed for a 12 volt electrical system with an alternator and a performance ignition coil of 35,000 V or more. 
• It is not compatible with a generator and cannot be used with a ballast resistor.
• Distributor gear is most compatible with cast iron hydraulic or solid flat tappet camshafts; consult camshaft manufacturer for recommended gear material before installation.

COMMON VEHICLE APPLICATIONS
Ford Mustang (351W, 1969–1973)
Ford Fairlane (351W, 1969–1970)
Ford Torino (351W, 1969–1976)
Ford Ranchero (351W, 1969–1979)
Ford Galaxie (351W, 1969–1974)
Ford LTD (351W, 1969–1982)
Ford Thunderbird (351W, 1977–1979)
Ford Bronco (351W, 1969–1988)
Ford F-Series (351W, 1969–1988)
Ford E-Series / Econoline (351W, 1969–1988)
Mercury Cougar (351W, 1969–1973)
Mercury Montego (351W, 1969–1976)

SPECIFICATIONS
Distributor Type: Pro Billet
Engine Platform: Ford Small Block Windsor V8
Trigger Type: Magnetic Pickup
Advance Type: Mechanical
Rotation Direction: Counterclockwise
Cap Color: Available in Black, Blue, Red
Terminal Gender: Male
Mechanical Tach Drive: No
Slip Collar: No
Coil Included: No
Coil Type: External
Coil Output: 35,000+ V
Gear Material: Steel
Housing Material: Machined Aluminum
Ignition Box Required: Yes
Marine Use: No
Cylinders: 8